Click image below to see printable street map in a new browser window.
Driving Directions to K&T Electrical Contractors, Inc. :
From Long Island/JFK:
Exit airport to Belt Parkway WEST.
Follow Belt Parkway to Varazano Narrows Bridge towards to Staten Island Expswy / NJ.
After Tolls, proceed (veer left) onto I-278 West to Gothels Bridge.
after Gothels, Bridge, Left exit onto I-95, New Jersey TURNPIKE SOUTH
From Newark International:
Exit airport WEST to New Jersey Turnpike.
After Tolls, Enter New Jersey TURNPIKE SOUTH.
From the North:
From NJ Turnpike (I-95 South), proceed to Exit 11, GSP south.
From the GSP (Garden State Parkway South), proceed south to exit # 120.
From the South:
From NJ Turnpike (I-95 North), proceed to Exit 11, GSP
south.
Alternately, northbound, you may jog to the GSP at I-195 exit-7A, north of Toms
River, to avoid
going north, just to come south over the Raritan River again. Fewer
Tolls as well...
From the GSP (Garden State Parkway North), proceed north to
exit # 120.
From GSP Exit-120::
From either the north or south-bound exits, turn right at
the end of the exit ramp onto Matawan Road..
Proceed to the first stop signal at Cliffwood Ave.. From there,
turn Left.
After crossing over the parkway, take the first left onto County Road.
County road curves right then crosses over NJT tracks.
K&T is on the Right side, Located in Suite-1 of the 403 County Road
Business Park.
Call +001 (732) 583-1133 Ext 0, if additional assistance is desired.
PS. Make sure you have lots of pocket change. or an EZ-Pass...